Epluser Co.,Limited
Categories

    Company:Epluser Co.,Limited

    Customer Service: 86-755-86652783

    Contact Address: 408, 4 Floor, C Area, B Block, West Silicon Valley, 5010 Bao'An Blvd, Bao'An, ShenZhen, GuangDong,518128, China

    Email: sales@eplastech.com

Home > News > Content

Injection Safety Precautions

Epluser Co.,Limited | Updated: Sep 25, 2015

1. upper and lower die. technician. foreman in split shot mouth or wash material tube Shi, must to with Shang anti-Burns mask and Canvas gloves, and to check temperature are not normal (absolute cannot partial high), dang shot not out rubber Shi must to with gas burn pass Hou, must put material tube inside of material shot finished Hou again split (but must to screw Rod pine back to 5-10 location), dang gags Shi burn not out, shot out end location for zero, to description screw Rod has anti-rubber, this situation Xia cannot hard shot, should first pine off II to three a teeth bit, stay temperature completely lowered Hou again split.

When using a washing machine at low temperature during high temperature tube, lock must not be used in case of heating water pipe blow, once the temperature screw down cleaning, all actions must be above and parallel to the machine, never stand in front of the nozzle (instructions wear protective mask).

2. all feed tube within 3 minutes of the down pipe to be cleaned to prevent carbide thermal decomposition (in particular, POM).


Contact Us
Address: 408, 4 Floor, C Area, B Block, West Silicon Valley, 5010 Bao'An Blvd, Bao'An, ShenZhen, GuangDong,518128, China
Tel: +86-755-86652783
 Fax:86-755-82976995
 E-mail:sales@eplastech.com